Follow

SMART Board 800 Series, USB Port Hierarchy with ECP and UX60-2

800 USB Port Hierarchy ECP UX60-2

UX60 projector with serial numbers GREATER than B012DExxxxx allow USB Mapping. USB1, USB2 ports can be assigned to VGA1, VGA2, HDMI or disabled. 
- The default configuration is USB1 - VGA1, and USB2 - VGA2

- If VGA1 is selected, the system will look for USB1. If it does not find anything on USB1, it will look for an accessory such as CAT5 or WC8. It will NOT look for USB2

- If VGA2 is selected, it will look for USB2. If USB2 is empty it will look for CAT5 or WC8. It will NOT look for USB1

- If HDMI is selected, the system will look for CAT5 or WC8

- USB B port on the bottom of the pen tray is used to connect the ECP to the pen tray

- The projector menu allows USB mapping for VGA1 and VGA2 and HDMi. If the default config is changed, the above descriptions will change:

- If VGA1 is selected, the system will look for the assigned USB port if any. If it does not find anything on the assigned USB port, it will look for CAT5 or WC8

- If VGA2 is selected, the system will look for the assigned USB port if any. If it does not find anything on the assigned USB port, it will look for CAT5 or WC8

- If HDMI is selected, the system will look for the assigned USB port if any. If it does not find anything on the assigned USB port, it will look for CAT5 or WC8

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments