Follow

SMART Board SD600 Series, dual touch calibration

SMART Board SD600 Series, dual touch calibration

  1. Open the SMART Board Tools Control Panel.
  2. Click the About Software and Product Support tab, click Tools, and then click Diagnostics.

The SMART Board Diagnostics screen appears.

  1. Select View> 600 Series Setup.

A button bar appears.

  1. Press Dual Calibration and follow the on-screen instructions.

NOTE: The Dual Calibration button appears only if an SC12 controller is

connected to a dual-touch interactive whiteboard.

  1. Once the Dual Calibration program is complete, close SMART Board Diagnostics

and orient the interactive whiteboard by pressing both pen tray buttons

simultaneously and then following the on-screen instructions.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments