Follow

SMART Board SB600 Series pen tray replacement

To replace the pen tray on a 600 Series SMART Board:

1) Remove the pens and eraser from the tray.
2) Disconnect the cable from the bottom of the tray on the right side.
3) Locate the two tabs on the bottom of the tray. Bend both of the tabs slightly downward at the same time and pull the tray away from the wall.
4) To install a pen tray, line up the two brackets on the wall with the slots above the tabs on the bottom of the tray. Slide the tray toward the wall until both tabs click into place.
5) Reconnect the cable to the bottom of the tray on the right side.
6) Place the pens and eraser in the appropriate slots.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments