Follow

SMART LightRaise 40wi, 60wi and 60wi2 Touch Detection Module (TDM) status lights

SMART LightRaise 40wi, 60wi and 60wi2 Touch Detection Module (TDM) status lights

TDM LIGHT: Solid Green
TOUCH INTERACTION: Full Control
STATUS: The Touch USB is connected, and Smart Drivers are running

TDM LIGHT: Flashing Green
TOUCH INTERACTION: Full Control
STATUS: The Touch USB is connected, and the default OS drivers are running. You might have single touch only, depending on your OS. Download and install appropriate SMART Drivers. SMART Downloads

TDM LIGHT: Flashing Amber/Red
TOUCH INTERACTION: No Touch
STATUS: The TDM is in red laser mode which is used during alignment. Wait 3 minutes for the red lasers to turn off or turn them off manually with the button on the TDM.

TDM LIGHT: Solid Green or Flashing Green
TOUCH INTERACTION: No Touch
STATUS: The USB Cable for touch isn't properly connected to your computer OR adjust the USB Mapping settings
*NOTE: Touch is disabled if the current input doesn't match the Touch setting in the OSD menu.

TDM LIGHT: Solid Red
TOUCH INTERACTION: No Touch 
STATUS: Connect the Touch USB cable

TDM LIGHT: Flashing Red/Amber
TOUCH INTERACTION: No Touch
STATUS: Hardware fault. Turn the projector off, disconnect power, reconnect power and then turn it back on again. If no change, please retrieve the serial number of the projector and submit a service ticket request. The projector will need to have it's warranty verified and it will either need to be repaired or replaced.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments